myAVR Pedestrian light


This example of use describes the building of a pedestrian light which will be switched via buttons. It is realized with the myAVR prototyping board A and the mySmartControl M8.

There are two possibilities to build the project:
  1. Project building without picture (technical)
  2. Project building with picture
If you take the variant with the picture then you have to pay attention that you fix the picture on the protoyping board before you assemble it. That makes the project more realistic. The picture is included in the project description where you can cut it out. Important is that you solder on the resistors on the backside of the prototyping board A which is untypical.

You can also realize the project without the picture.

Picture to cut it out and fix it on the prototyping board A


You can download the whole project as pdf:

Shopping list:

For this project you need the following things:

  • 1 mySmartControl M8 or M168 (
  • 1 myAVR Laborkarte A (
  • 10 resistors 1,2 kOhm (specialist shop)
  • 4 red LEDs (specialist shop)
  • 4 green LED (specialist shop)
  • 2 yellow LED (specialist shop)
  • 2 buttons 9 mm (specialist shop)
  • Connection cable (patch cable) (
  • Brazing soldering equipment (

««« Back to picture gallery  

Our regional partners

Business partner wanted!

To expand our sales area we are looking for partners to represent our products and interests of the SiSy Solutions GmbH.


For beginners

Controller board